TM 9-6115-729-24
0013
ELECTRONIC TECHNICIAN (ET) TROUBLESHOOTING - Continued
CORRECTIVE ACTION - Continued
NOTE
The bracket cannot be replaced separately. Bracket and sensors must be replaced as an
assembly.
d. Disconnect connector ENG-P4 from the primary (top)engine timing sensor
and connector ENG-P5 from the secondary (bottom) engine timing sensor.
Remove bolt (Figure 5, Item 4) and washer (Figure 5, Item 5) and remove the
sensor assembly from the engine (Figure 5, Item 1).
e. Ensure that one O-ring (Figure 5, Item 6) is installed on each sensor. Check
the O-rings for damage. Replace the O-rings, if necessary.
