ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
Assembly Instructions
7.
Using a suitable container (2-gallon capacity), drain the set fuel tank by opening the drain cock
8.
Turn the handle on the fuel filter (Figure F-3, Item No. 18) to the up position to close the filter.
Disconnect the fuel supply hose (Figure F-3, Item No. 10) from the input side of the fuel filter by
9.
Remove the elbow barb fitting and hose (Figure F-3, Item Nos. 12 and 10) from the bottom of the fuel
and discard. Loosen the hose clamp (Figure F-3, Item No. 11) on the elbow barb fitting, remove the
hose and discard it. Retain the elbow barb fitting.
10. Attach the 3-way valve assembly to the bracket, Item No. 17, using two (2) each machine screws,
lock-spring washers, flat washers, and machine nuts (Item Nos. 18, 19, 20, and 21). The order of
assembly should be screw, bracket, 3-way valve assembly, flat washer, lock-spring washer, and
machine nut.
11. Facing the fuel tank side of the generator set, disassemble the capscrew, plain washer, lock-
spring washers (2), and hex nuts (2) attaching the ground braids (2) to the generator cross member
(Figure F-1, Item Nos. 29, 24, 23
(2), 26
(2), 25
and 27). Place the bracket assembly on
the cross
member so that the bent flange is against the side of the cross member and the 3-way valve
assembly faces out. Reassemble the screw, washers, ground braids and nuts through the bracket
in their original configuration.
12. Slide one hose clamp, Item No. 5, onto hose, Item No. 16. Slide end of hose, Item No. 16, over the
was removed (see step 9 above). Insert rubber bushing, Item No. 25, into the bottom of the set tank.
Insert elbow barb fitting with hose, Item No. 16, into the rubber bushing, Item No. 25. Slide hose
clamp, Item No. 5, over the elbow barb fitting and tighten.
13. Slide one hose clamp, Item No. 5, onto hose, Item No. 9. Slide end of hose, Item No. 9, onto the
input fitting of the fuel filter (Figure F-3, Item No. 18). Slide hose clamp, Item No. 5, over the fuel
filter fitting and tighten. Turn the handle on the fuel filter down to open the fuel filter.
CAUTION
After installing the Auxiliary Fuel System, check to
ensure none of the hoses come into contact with sharp
edges. It may be necessary to reorient the hose clamps.
14. Attach the fuel can bracket, Item No. 22, to the generator set frame by tilting the bracket so that the
ears on the end of the bracket will slide under the top longitudinal members of the set frame. Hook
the bracket over the end of the frame.
15. Set the auxiliary fuel can into the bracket and secure with the strap, Item No. 23.
CAUTION
When installing the fuel primer bulb assembly, Item
No. 2, into the auxiliary fuel can, do not let the hose
come into contact with the muffler or any other
potentially hot surfaces.
L-5