ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
Auxiliary Fuel System Instructions
WARNING
The fuels in this generator set are flammable. Do not
smoke or use open flames when performing
maintenance. Do not service or drain the fuel system
while open flames are present. Flames and explosion
could result in severe personal injury or death. Use a
container or cloth to catch any excess fuel to prevent
spilling over engine components. Be sure to properly
dispose of diesel fuel and diesel fuel soaked cloths.
CAUTION
After installing the Auxiliary Fuel System, check to
ensure none of the hoses come into contact with sharp
edges. It may be necessary to reorient the hose clamps.
CAUTION
When installing the fuel primer bulb assembly, Item No.
2, into the auxiliary fuel can, do not let the hose come
into contact with the muffler or any other potentially hot
surfaces.
Fabrication Instructions
1. The following brackets need to be fabricated at a machine shop:
a. 3-way valve bracket in accordance with Figure L-2.
b. Fuel can bracket in accordance with Figure L-3.
Tools Required for Pre-assembly, Assembly, and Disassembly
2.
The following tools are required for pre-assembly, assembly, and disassembly of the Auxiliary Fuel
System:
a.
Hose cutter.
b.
Two (2) crescent wrenches.
c.
Measuring device.
d.
Screwdriver.
Pre-assembly Instructions
3. Using a 4-1/2-foot (54-inch) section of 5/16-inch ID hose, cut four (4) sections of hose in the following
lengths:
a.
One (1) 2.0-inch length (Item No. 6).
b.
One (1) 29.0-inch length (Item No. 8).
c.
One (1) 9.0-inch length (Item No. 9).
d.
One (1) 8.0-inch length (Item No. 16).
L-3
