ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
CAUTION
DO NOT REMOVE power harness components unless testing results in a need
to replace stator assembly. Unnecessary removal and installation of
components is time consuming and damage may occur.
(5)
If necessary to replace stator assembly (18), remove power harness components as follows:
(a)
Remove nut (39), lockwasher (38), washer (37), and screw (36) securing clamp (35) to
bracket (17).
(b)
Cut tiedown straps (30) and remove convoluted tubing (31) and insulation sleeving (40) from
cable.
(c)
Cut cable wires four inches down from clamp (32).
(d)
Remove grommets (41) from stator assembly (18) and slide off cable wires.
f.
Assembly.
NOTE
If replacing rotor (21, Figure 5-39), also replace bearing bracket (16) and
bearing (29).
(1)
If stator assembly (18, Figure 5-39) was replaced, install power cable components as follows:
(a)
Slide grommets (41) over cable wires and install in vent holes where cable wires exit stator
(b)
Position insulation sleeving (40) on cable wiring. Then push wiring through clamp (32).
(c)
Match cable wire numbers to corresponding plug wires and splice together. Refer to Table
(d)
Position convoluted tubing (31) on cable wires and secure with tiedown straps (30).
(e)
Secure harness to support bracket (17) with clamp (35), screw (36), washer (37), lockwasher
(38), and nut (39).
(2)
If removed, install bearing (29) in rotor (21).
(3)
Insert thru bolts (28) in adapter plate (27).
(4)
Install fan (23) on rotor (21) with washers (34) and bolts (22).
5-76
