ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
(4) Close and secure instrument panel.
b.
Removal.
(1) Shut down generator set.
(2) Release instrument panel by turning fastener, open instrument panel slowly.
(3) Remove locknuts and washers (Figure 4-30) securing transient suppressor
assembly to load terminals (+) and (-). Then remove transient suppressor
assembly.
c.
Testing.
(1) Shut down generator set.
(2) Release instrument panel by turning fastener, open instrument panel slowly.
(3) Disconnect transient suppressor assembly from positive load terminal.
(4) Using multimeter, set for ohms, note resistance across terminals. Reverse leads
and note resistance.
(5) Resistance should be high in one direction and low in the other. If resistance is
high or low in both directions, replace suppressor.
RT
STA
F
OF
T
EA
EH
PR
RT
STAEAT
EH
PR
CA
UT
ION
28
VD
C
WASHER
TRANSIENT
LOCKNUT
SUPPRESSOR
WASHER
ASSEMBLY
LOCKNUT
