ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
AIR INTAKE SYSTEM COMPONENTS.
a.
Removal.
(1) Shut down generator set.
(2) Remove wing nut (Figure 4-16), cover, and filter element with pre-filter.
(3) Remove pre-filter from filter element.
(4) If necessary, remove gaskets from mounting plate and cover. Clean adhesive
residue from surfaces.
b.
Inspection/Cleaning.
(1) Inspect cover (Figure 4-16) for cleanliness, cracks and other damage. Clean cover
with mild soap and water.
(2) Inspect filter element for cleanliness, dents, and crushed corrugations. Replace if
damaged.
(3) Discard pre-filter.
(4) Replace damaged parts.
(5) If damaged, replace machine screw in mounting plate. Use locking compound
(Item 6, Appendix E) to secure machine screw in mounting plate.
c.
Installation.
(1) If removed, install new gasket (Figure 4-16) on cover.
(2) Position air filter element on mounting plate and mark position for gasket on plate.
Remove air filter element and install new gasket on mounting plate with adhesive
side toward mounting plate.
FILTER
GASKET
ELEMENT
PRE-FILTER
GASKET
COVER
WING
NUT
MACHINE
SCREW
MOUNTING
PLATE
