ARMY TM 9-6115-67313&P
AIR FORCE TO 35C2-3-512-1
(6) Inspect elbows (16 and 18) and bushings (17 and 19) for physical damage, leaks,
and security.
d.
Assembly.
WARNING
Adhesive (Item 1, Appendix E) is flammable and toxic. Vapors
may ignite explosively. Avoid breathing in vapors. Provide
adequate ventilation to prevent vapor concentrations in excess
of permissible exposure levels. Keep away from heat, sparks,
and open flame. Do not smoke. Extinguish all flames and turn
off non-explosion-proof electrical equipment during use until
vapors are dissipated. Close container tightly after use.
Contains Methylethketone. Avoid swallowing.
(1) If removed, install rubber straps (20, Figure 4-15) on fuel tank (9). Make sure fuel
tank is clean and free of oil, dirt, and grease. Then cut rubber straps and secure
with adhesive (Item 1, Appendix E). Follow adhesive manufacturer's instructions
for application.
(2) Install bushings (19 and 17) in fuel tank (9), and elbows (18 and 16) in bushings.
(3) Install adapter (15) in fuel tank (9). Torque adapter to 40 lbs-in (4.5 Nm), then
install fuel drain cock (14) in adapter.
(4) Install filter (13) and fuel cap (12) on fuel tank (9).
e.
Installation.
(1) Position guard (11, Figure 4-15) and lower fuel tank brackets (10) in generator set
frame.
(2) Place fuel tank (9) in lower fuel tank brackets (10).
(3) Secure fuel tank (9) in generator set with upper fuel tank brackets (8), washers (7),
lockwashers (6), and capscrews (5) ensuring fuel cap (12) wire rope is secured
under rear right side hardware.
(4) Connect fuel return line tubing (4) to elbow (18) with hose clamp (3).
(5) Connect tank-to-filter fuel line tubing (2) to elbow (16) with hose clamp (1).
(6) Fill fuel tank with diesel fuel (DL-1, DL-2, or JP-8).
(7) Prime and bleed the fuel system, refer to paragraph 2.7.c.
4-61
