ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
5-20
(15) Remove bracket clamp bolts.
(16) Remove fuel pump fittings.
(17) Remove oil sampling valves.
b.
Compare New and Old Engine.
Compare new and old engines. Remove components unique to the old engine and install these on the
new engine prior to installation in the generator set.
c.
Installation.
(1)
Install rear engine lifting bracket (54, Figure 5-1), lockwasher (53), and bolt (52), lockwasher
(51), and bolt (50) on engine.
(2)
Install front engine lifting bracket (49), lockwashers (48), and bolts (47) on engine.
__________
WARNING
Generator is heavy. Obtain assistance when moving generator with hoist.
Failure to comply can cause injury to personnel.
CAUTION
Generator is heavy. Rated capacity of overhead hoist should be at least
1,000 lb. (454 kg). Failure to comply can cause damage to equipment.
(3)
Attach lifting harness to overhead hoist and generator lifting eye. Take up slack on harness.
(4)
Position generator to mount onto engine. Ensure generator drive disc is aligned with engine
flywheel. Note scribe mark made at removal. Install bolts (40), lockwashers (41) and washer
(42) into flywheel housing.
(5)
Secure generator to engine flywheel housing with washers (42), lockwashers (41), and bolts
(40). Torque bolts to 25 ft-lb (33.9 Nm).
(6)
Secure generator drive disc to engine flywheel with washers (39) and bolts (38). Torque bolts to
25 ft-lb (33.9 Nm).
(7)
Install band cover (37), washers (36), screws (35), lockwashers (34), and nuts (33) on generator
case.
(8)
Detach lifting device from generator lifting eye.
(9) Install engine and generator assembly, paragraph 5.4.2
