ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-175
(10) Loosen hose clamps (25 and 26). Remove filler neck (24), fuel fill hose (27), and hose clamps from
generator set.
b. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove fuel tank filler neck, step a above.
(3)
Inspect fuel fill hose (27, Figure 4-26) for cracking, wear, or other damage.
(4)
Inspect filler neck (24) for corrosion, cracking, or other damage.
(5)
Inspect filler neck tube and cap assembly (15) for damage.
(6)
Replace damaged parts.
(7)
Install fuel tank filler neck, step c below.
c. Installation.
(1)
Position fuel fill hose (27, Figure 4-26), clamps (25 and 26), and filler neck (24) on fuel tank.
(2)
Secure filler neck (24) to filler neck panel with bolts (23) and locknuts (22).
(3)
Tighten hose clamps (25 and 26).
(4)
Install reducer (21), washer (20), and seal nut (19) on side of filler neck (24).
(5)
Install connector (18) on reducer (21).
(6)
Position hose clamp (16) on hose (17). Connect hose to connector (18), and tighten hose clamp.
(7)
Install filler neck tube and cap assembly (15) in filler neck (24).
(8)
Close engine compartment access doors.
(9)
Close fuel drain valve (30), install cap (28), and service fuel tank. Refer to Table 4-2 for proper
fuel.
(10) Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.11.4 Fuel Drain Valve.
Replacement.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Open left side engine compartment access doors (Figure 1-3).
(4)
Remove cap (28, Figure 4-26) from adapter (29).
