ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
5-30
(16) Remove screws (7), washers (8), and cover (9) from AC circuit interrupter (35).
(17) Tag and disconnect output cables from terminals A2, B2, and C2 of AC circuit interrupter (35).
(18) Tag and disconnect exciter leads F1 and F2 from terminals 1 and 2 of terminal board (29).
(19) Remove locknuts (10), bolts (11), and output box assembly from generator set.
b. Installation.
(1)
Install output box assembly on generator set with bolts (11, Figure 5-3) and locknuts (10).
(2)
Connect exciter leads F1 and F2 to terminals 1 and 2 of terminal board (29). Remove tags.
(3)
Connect output cables to terminals A2, B2, and C2 of AC circuit interrupter (35). Remove tags.
(4)
Install cover (9), washers (8), and screws (7) on AC circuit interrupter (35).
(5)
Install main generator cables on current transformer (34) and droop current transformer (33) the
same number of wraps recorded during removal.
(6)
Install output box top panel (6), bolts (5), and locknuts (4) on output box assembly.
(7)
Install voltage reconnection terminal board, paragraph 5.8.2.
(8)
Install loop clamps (3), screws (2), and locknuts (1) on wiring harness (31) and side panel (32).
(9)
On right side of engine, connect electrical leads from battery charging alternator, starter, ether
solenoid valve, crankcase breather assembly heater wires, slave cables and battery cables. Refer
to paragraph 4.11.9 and TM 9-2815-259-24. Remove tags.
(10) Connect electrical leads to fuel injection pump (refer to TM 9-2815-259-24), electric actuator
(refer to paragraph 5.10.1), DEAD CRANK switch (refer to paragraph 4.13.4), oil pressure
sender (refer to paragraph 4.13.1), coolant temperature sender (refer to paragraph 4.13.2),
auxiliary fuel pump (refer to paragraph 4.11.2), fuel pickup (refer to paragraph 4.11.6), fuel
level sender (refer to paragraph 4.11.5), and magnetic pickup (refer to paragraph 4.13.3).
Remove tags.
(11) Install rear housing panel. Refer to paragraph 4.7.5.
(12) Install output box access door. Refer to paragraph 4.7.1.
(13) Install air cleaner assembly, paragraph 4.9.2.
(14) Install top housing section, paragraph 4.7.3.
(15) Install DCS control box assembly, paragraph 4.8.1.
(16) Close engine compartment access doors.
(17) Connect negative battery terminal to battery, and close BATTERY ACCESS door.
