ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
5-1
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
CHAPTER INDEX
SECTION I
REPAIR PARTS, TOOLS, TEST, MEASUREMENT AND DIAGNOSTIC
(TMDE, AND SUPPORT EQUIPMENT......................................................................................5-1
SECTION II
LUBRICATION PROCEDURES..................................................................................................5-1
SECTION III
TROUBLESHOOTING.................................................................................................................5-2
SECTION IV
DIRECT SUPPORT MAINTENANCE PROCEDURES............................................................5-14
NOTE
Procedures may require CD-ROM. See Appendix C.
SECTION I. REPAIR PARTS; TOOLS; TEST, MEASUREMENT
AND DIAGNOSTIC (TMDE); AND SUPPORT EQUIPMENT
5.1
INTRODUCTION.
5.1.1
Maintenance Repair Parts. Repair parts and equipment are listed and illustrated in the Repair Parts and
Special Tools List (RPSTL) manual TM 9-6115-671-24P.
5.1.2
Tools and Equipment. There are no special tools or support equipment required to perform direct support
level of maintenance on the generator set. A list of recommended tools and support equipment required to
maintain the generator set is contained in Appendix B, Section III.
5.1.3.
Fabrication of Tools and Equipment. No requirement exists for fabrication of tools and equipment for
maintenance of the generator set.
SECTION II. LUBRICATION PROCEDURES
5.2
DIRECT SUPPORT LUBRICATION INSTRUCTIONS. There are no special lubrication instructions
required to perform direct support level of maintenance. Refer to LO 9-6115-644-12 for generator set
lubrication requirements.
