ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-164
(7)
Install support tie-rods (24), washers (23), bolts (22), lockwashers (21), and nuts (20) on bracket on
engine.
(8)
Install lower coolant hose, paragraph 4.10.5.
(9)
Install upper coolant hose, paragraph 4.10.4.
(10) Install fan guards, paragraph 4.10.3.
(11) Install top section housing, paragraph 4.7.3.
(12) Install filler hose and panel, paragraph 4.10.2.
(13) Close coolant drain valve (33), and add coolant/antifreeze to proper level, paragraph 3.3.4.
(14) Install radiator cap (1) on filler neck (2).
(15) Start generator set, paragraph 2.11.1. Allow unit to reach operating temperature, and check for
leaks.
(16) Add coolant/antifreeze to overflow bottle as required.
(17) Close engine compartment access doors.
4.10.8 Fan.
a. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Open engine compartment access doors (Figures 1-2 and 1-3).
(4)
Remove fan guards, paragraph 4.10.3.
(5)
Remove bolts (16, Figure 4-22), lockwashers (17), and washers (18), and allow shroud (19) to rest
on fan (40).
(6)
Remove bolts (38), lockwashers (39), fan (40), and spacer (41) from engine water pump.
(7)
Remove locknuts (42), screws (43), stiffeners (44), supports (45), and seals (46) from shroud (19).
b. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove fan, step a above.
(3)
Inspect fan (40, Figure 4-22) and blades for cracks, bends, loose rivets, or other damage.
