ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-115
(11) Install standoffs (21), backplane module (20), washers (19), and locknuts (18) on DCS control box
rear panel.
(12) Connect P23 (17) and P8 (33) ribbon cable assemblies to backplane module (20).
(13) Secure backplane connectors (16) to DCS control box rear panel with washers (15), lockwashers
(14), and screws (13).
(14) Connect wiring harness connectors (12).
(15) Install automatic voltage regulator, paragraph 4.8.23.
(16) Install DCS speed control unit, paragraph 4.8.22.
(17) Install DCS load sharing synchronizer, paragraph 4.8.21.
(18) Install DCS control box top panel, paragraph 4.7.2.
4.8.25 I/O Interface Module A5.
CAUTION
Electronic components containing printed circuit boards are extremely
sensitive to electrostatic discharge (ESD). Wear an ESD wrist strap connected
to ground whenever coming in contact with ESD-sensitive components. Failure
to comply can cause severe damage to equipment.
a. Inspection
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove DCS control box top panel, paragraph 4.7.2.
(3)
Attach ESD wrist strap and connect to ground.
(4)
Inspect I/O interface module (25, Figure 4-15) for damaged or missing connectors and components.
(5)
Disconnect ESD wrist strap, and remove wrist strap.
(6)
Install DCS control box top panel, paragraph 4.7.2.
