ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-79
.
(7)
Remove bolts (6 and 9), lockwashers (7 and 10), washers (8 and 11).
(8)
Slide DCS control box forward, disconnect two wiring harness connectors at rear of DCS control
box assembly (12, Figure 4-10) and remove DCS control box assembly (12) from generator set.
c. Repair
Repair DCS control box assembly by replacing damaged terminals, damaged or missing mounting
hardware, and damaged or defective components. Refer to paragraphs 4.8.2 through 4.8.43.
d. Installation.
(1)
Install DCS control box assembly (12) to generator set by sliding DCS control box backward, and
connecting two wiring harness connectors at rear of DCS control box assembly (12, Figure 4-10).
(2)
Secure DCS control box assembly (12) to generator set with bolts (6 and 9), lockwashers (7 and 10),
and washers (8 and 11).
(3)
Install bolts (5) and locknuts (4).
(4)
Close output box access door (Figure 1-2).
(5)
Secure DCS control box assembly (12, Figure 4-10) to top of output box assembly with washers (3),
lockwashers (2), and bolts (1).
(6)
Connect two wiring harness connectors at rear of DCS control box assembly (12).
(7)
Install DCS control box top panel, paragraph 4.7.2.
(8)
Connect negative battery cable to battery, and close BATTERY ACCESS door (Figure 1-2).
4.8.2
Panel Lights DS1 through DS3.
a. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove directional cap (1, Figure 4-11) from panel light housing (5).
(3)
Remove light bulb (2) from panel light housing (5).
(4)
Set multimeter to ohms, and check light bulb for continuity across base and threads. Multimeter
should indicate continuity.
(5)
If multimeter does not indicate continuity, replace light bulb (2).
(6)
Inspect directional caps (1) for cracks, corrosions, stripped threads, and other damage.
(7)
Release DCS control panel by turning two fasteners, and lower panel slowly.
