ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-57
4.7
MAINTENANCE OF HOUSING
__________
WARNING
When disconnecting or removing batteries, disconnect the negative lead that
connects directly to the grounding stud first. Disconnect the negative end of
the interconnection cable next. When installing batteries, reverse the
connection sequence. Failure to comply can cause serious personal injury.
4.7.1
Access Doors.
NOTE
This procedure is written for the left rear engine access door, but is typical for all
access doors, hinges, latches, storage boxes, and data plates.
NOTE
When removing and installation BATTERY ACCESS door, note position of spacers
for door hold open mechanism.
a. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open left side engine compartment access doors (Figure 1-3).
(3)
Remove nuts (1, Figure 4-5), lockwashers (2), washers (3), bolts (4), and hinges (5), with door (6)
attached, from generator set housing.
(4)
Remove nuts (7), lockwashers (8), washers (9), bolts (10), and hinges (5) from door (6).
(5)
Remove locknuts (11), bolts (12), and document box (13) from door (6).
(6)
Drill out rivets (14), and remove fuel system diagram data plate (15) from document box (13).
(7)
Remove locknuts (16), bolts (17), and bracket (18) with holding rod (19) from door (6).
(8)
Remove locknuts (20), bolts (21), and bracket (22) from door (6).
NOTE
Note position of latches before removal for reference during installation.
(9) Remove locknuts (23), screws (24), and latches (25) from door (6).