ARMY TM 9-6115-670-14&P
5-70
y. Install three bolts and lock washers (4, Figure 5-17) (JTACS), or three bolts, flat and lock
washers (SICPS and WIN-T), to regulator box (2), electrical leads and ground wire. Secure to
generator housing.
z. Install six nuts with captive washers (8, Figure 5-12) (JTACS) securing relay board (6) to
vibration mounts (3), or six screws, flat and lock washers, vibration mounts (3) and hex nuts
(SICPS and WIN-T) securing relay board (6) to relay box.
aa. Refer to FO-1 (SICPS, WIN-T) or FO-7 (JTACS) and install electrical leads U1T1, U5T3 and
U6T4 to terminals 1,3 and 5 on the main contactor.
ab. Refer to FO-1 (SICPS, WIN-T) or FO-7 (JTACS) and install ground wire U2L0 to the electrical
output terminal board inside the generator housing.
ac. Refer to FO-1 (SICPS, WIN-T) or FO-7 (JTACS) and install electrical leads F1 and F2 to relay
board inside regulator box.
ad. Install four screws (JTACS), or four slotted hex-head screws (SICPS and WIN-T), flat and lock
washers (5, Figure 5-12) to generator housing side cover (4) and secure to generator housing
(fuel pump side).
ae. Install two screws, wing nuts and lock washers (9a, Figure 5-18) (JTACS), or four slotted hex-
head bolts (SICPS and WIN-T), flat and lock washers to generator housing side cover (8) and
secure to generator housing (muffler side).
af. Install generator housing top cover (5) and secure with four screws (JTACS), or slotted hex-
head bolts (SICPS and WIN-T), flat and lock washers (4).
