TM 9-6115-669-13&P
WARNING
For safety reasons (load imbalance), always use the forklift
on the side of the pallet frame where the cable drums are
located.
Do not stand in the forklift operating area. Do not walk
under the suspended load
CAUTION
Use only forklifts with a fork length of at least 80 inches (2000 mm) and a
capacity of approximately 12,000 lb. (6 metric tons). Place a mark at 20 inches
(500 mm) as shown in figure 4-29.
a.
Position forklift in front of pallet frame (1) and insert forks into forklift sockets to the 20
inches (500 mm) mark as shown in the figure. This distance is necessary in order to place the
pallet frame on the truck.
CAUTION
Arrange PDU connector cable (8, figure 4-28) on the pallet frame so it can
not be damaged when the pallet frame is set down.
b.
Perform steps c. through g. in “Installation Using a Crane”.
c.
Remove forklift and perform steps i. through n. in “Installation Using a Crane”.
Figure 4-29 Installing the Pallet Frame on the Truck Red wring a Forklift.
4-65
