TM 9-6115-669-13&P
a.
To repair a defective ground strap (3):
(1) Remove nut (4), serrated washer (5), washer (6), and ground strap (3) from grounding
bolt.
(2) Install new ground strap (3), washer (6), serrated washer (5) and nut (4). Torque nut
(4) to torque value 18.42 ft-lb (26 Nm).
(3) Apply terminal grease to threaded connection.
b.
To remove a defective bracket (11):
(1) Remove two screws (8), serrated washer (9) and washer (10), and defective bracket (11).
(2) Install new bracket (11), washer (10), serrated washer (9) and two screws (8).
c.
To repair a defective chain (14):
(1) Remove nut (17), serrated washer (16), washer (15), chain (14), washer (13) and screw
(12). Detach splint and ring from chain.
(2) Install new chain (14) with splint and ring, using screw (12), washer (13), washer (15),
serrated washer (16), and nut (17). Tighten nut (17).
d. To repair a defective chain (22):
(1) Remove nut (25), serrated washer (24), washer (23), chain (22), washer (21) and screw
(25).
(2) Remove chain (22), with splint and ring, from stud (26).
(3) Install new chain (22), with splint and ring, on stud (26).
(4) Install chain (22) with screw (20), washer (21, 23), serrated washer (24), and nut (26).
Tighten nut (25).
a.
Remove sling assembly (14, figure 4-26) from pallet frame. Suspend sling assembly from crane.
Position crane approximately centered over the three lifting lugs (16) of the pallet frame.
b.
Engage the three cables of the sling assembly in the three lifting lugs (16).
CAUTION
Arrange the PDU connector cable (16) on the pallet frame so it cannot be
damaged when the pallet frame is set down.
c.
On the truck bed, fold the side panels (1, figure 4-28) and tailgate (2) down to the horizontal
position for access. On the opposite side, fold the side panel (1) all the way down. The pallet
frame will be installed from this side.
d.
Install guide mandrels (4) into holes (3, 7).
4-62
