TM 9-6115-669-13&P
4.17 GENERATOR SET 150 KW MAINTENANCE.
This task covers:
a. Removal
b. Inspection
c. Installation
General Mechanic’s Tool Kit
(item 2, appendix B)
Automotive Fuel and Electrical System Repair, Tool
Kit
(item 3, appendix B)
Torque wrench
Load Bank (item 23, appendix B)
Reference
Shut down Generator Set
150 kW, paragraph 2.8.1.
Terminal grease
(item 4, appendix E)
Copper paste
(item 5, appendix E)
N O T E
For removal and installation, proceed according to appropriate
paragraphs depending on whether a crane or forklift is available.
Swing truck side panels (14, figure 4-20) down to horizontal position
for access.
Never attempt to disconnect control or power cables while the
Generator Set 150 kW is running. Failure to observe this
warning could result in severe personal injury or death by
electrocution.
a.
Proceeding from left to right in the sequence (1), (2), (3), (4), swing cable drums (1 to 4)
forward in operating position and lock in place, so the two Generator Sets 150 kW connection
panels (5) are accessible.
Change 1
4-45
