TM 9-6115-664-13&P
5-12. CAMSHAFT MAINTENANCE
This task covers removal, inspection, and installation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
Engine Removed (Para. 5-8)
and Repair (Item 4, App. B)
Engine Start Solenoid Removed (Para. 4-45)
Mechanical Fuel Pump Removed (Para. 4-55)
Parts/Materials:
Cylinder Head Removed (Para. 5-9)
Loctite Adhesive (Item 1, App. E)
Fuel Injection Pump Removed (Para. 5-10)
Cleaning Solvent, PD-680 (Item 9, App. E)
A.
REMOVAL.
NOTE
Remove crank handle guide (1,
Figure 5-6) only if inspection of oil
seal (4) is required.
1.
Remove crank handle guide (1) from camshaft
assembly (3) by removing three screws (2).
2.
Remove cover (9) and gasket (10) by removing
two screws (8). Discard gasket.
3.
Remove camshaft assembly (3) from engine block
(7) by removing seven screws (5). Remove and
discard gasket (6).
B.
INSPECTION.
WARNING
Cleaning
solvent,
PD-680,
is
potentially dangerous to personnel
and
property.
Skin
and
eye
protection
is
required.
Good
ventilation
is
required.
Avoid
repeated and prolonged skin contact.
Do not use near open flame or
excessive heat. Flash point is 200° F
(93.3° C).
Figure 5-6. Camshaft
(Sheet 1 of 2)
5-35
