TM 9-6115-664-13&P
4-12.
COVER ASSEMBLY MAINTENANCE
This task covers removal, disassembly, inspection, repair, assembly, and installation
INITIAL SETUP
Tools:
Personnel Required:
Shop Equipment, Automotive Maintenance
2 Maintenance Personnel
and Repair (Item 1, App. B)
Parts/Materials:
Equipment Condition:
Adhesive, Loctite (Item 1, App. E)
Control Panel Removed (Para. 4-20)
Adhesive, Silicon (Item 2, App. E)
Adhesive, Contact Spray On (Item 12, App. E)
Tape, VHB (Item 8, App. E)
A.
REMOVAL.
1.
Lift and turn four latches (1, Figure 4-2) to unlock
covers (2, 3).
NOTE
Discard and replace all lockwashers
and locknuts when removed.
2.
Remove four screws (4), eight washers (5), and four
locknuts (6) that secure cross member (7) to support
brackets (8, 9).
WARNING
Cover
assembly
is
heavy
and
awkward. Enlist help of an assistant
when removing.
3.
With the help of an assistant, lift cover assembly up
and off APU enclosure.
4.
Remove mounting bracket (8) from enclosure by
removing four screws (10), eight washers (11), and
four locknuts (12).
5.
Remove mounting bracket (9) from enclosure by
removing four screws (13), eight washers (14), and
four locknuts (15).
Figure 4-2. Cover Assembly
(Sheet 1 of 4)
4-38
