TM 9-6115-647-14&P
4-27.
Fabrication of Power Source Jumper Cable. (See table 4-3)
Table 4-3 Fabrication of Power Source Jumper Cable
Nomenclature
*Reference No
Material Required
Clip, Electrical (Black)
63CBLK
Clip, Electrical (Red)
63CRED
Cartridge, Fuse
FHN31G1
Fuse, 5A SLOBLO
LO1323
Cable, 2-Conductor, 12' Long
CO-02 LLF (2/16) 0230
Clip, Electrical Test (Red)
48B
Clip, Electrical Test (Black)
2711
*Refer to figure D-23 for NSNs.
Fabrication Instructions:
1.
Strip ½ -inch of insulation at each end of cable and separate two conductors at each end.
2.
At one end of cable, solder black test clip to one conductor and red test clip to second conductor.
3.
At opposite end of cable, solder black clip to conductor bearing black test clip.
4.
Insert fuse into cartridge and solder one end of cartridge to remaining conductor, and opposite end to
red clip.
4-44
