TM 9-6115-647-14&P
a.
Removal.
(1)
Remove generator set (paragraph 5-2).
(2)
Remove walkways (paragraph 4-31).
(3)
Fuel cable is fastened to front support (1, figure 5-13) with one clamp (2) . Fuel line is
fastened to front support with one clamp and to middle-front support with two clamps . When
removing front or middle-front support, remove screws (4), lockwashers (5) and clamps as
necessary and remove fuel cable and/or fuel line from support.
(4)
When removing rear support (6) or middle-rear support (7), remove storage tray cover (8)
(paragraph 5-14).
(5)
Remove four screws (9), eight flat washers (10) and four self-locking nuts (11) and lift support
(1,3,6 or 7) off trailer frame (12).
b
Repair. The generator set supports may be repaired by drilling out damaged threaded inserts and
replacing them with new ones, or by welding or repainting. If repaired, repaint in accordance with
MIL-T-704, Type G, Color Green, No 383 of MIL-C-46168.
c.
Installation.
NOTE
When installing front or middle-front support, position support so that clamp
mounting holes are center and curbside.
(1)
Position support (1,3,6 or 7) on trailer frame (12) and fasten with four screws (9), eight flat
washers (1.0) and four self-locking nuts (11). Torque to 57 to 63 foot-pounds (77.81 to 86.00
newton-meters).
(2)
When installing rear support (6) or middle-rear support (7), install storage tray cover (8)
(paragraph 5-14).
(3)
When installing front support (1) or middle-front support (3), reconnect fuel cable and/or fuel
line, to supports with screws (4), lockwashers (5) and clamps (2) as necessary.
(4)
Install walkways (paragraph 4-31).
(5)
Install generator set (paragraph 5-2).
Change 1
5-25
