TM 9-6115-646-14&P
(2)
Thread one end of auxiliary fuel line onto fuel can adapter fitting and tighten
(3)
Connect free end of auxiliary fuel line to FUEL SUPPLY INLET connection This connection is located next to the
fuel filler above the trailer roadside fender
(4)
Insert fuel can adapter In external fuel source and secure by pressing down on lever
(5)
Set FUEL SELECTOR valve above fuel filler, to AUXILIARY position
Figure 4-4. External Fuel Line Connection.
Section II. MOVEMENT TO A NEW WORKSITE
4-3.
Dismantling for Movement. Because the power unit is designed to be mobile, a minimum amount of effort is
required to relocate to a new worksite Procedures are as follows
a
Disconnect power unit from system or equipment being powered
b
Disconnect ground cable from source of ground and from power unit GROUND TERMINAL Roll up cable and
store In accessory stowage chest
c
Using slide hammer, remove ground rod Disassemble, clean, and stow ground rod In accessory stowage chest
d
Disconnect power unit from external fuel source, If applicable
4-6
