TM 9-6115-646-14&P
CHAPTER 4
UNIT MAINTENANCE
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
4-1.
Inspecting and Servicing Equipment. The power unit is unpacked, inspected, and serviced as described In the
following paragraphs Unpacked equipment must be checked against the Equipment Packing List to insure completeness
Discrepancies must be reported In accordance with Instructions In DA Pam 738-750
a.
Unpacking Power Unit. (See figures 4-1 and 4-2 ) The generator set is packed In place on the trailer frame
Before beginning the unpacking procedure, locate remove, and save the waterproof envelope marked Depreservation
Guide.
WARNING
The steel banding used In packaging of power unit has sharp edges Care should be taken when cutting
and handling banding to avoid injury to personnel
(1)
Remove steel banding around plywood box covering generator set and drop plywood cover from beneath
generator set
(2)
Remove lag screws securing plywood box cover over generator set and lift box off generator
(3)
Remove wooden wedges and spacers from around generator set base
(4)
Remove and save package of technical manuals secured to barrier material covering generator
(5)
Remove barrier material from generator set
(6)
Remove packaged fire extinguisher from within generator set enclosure Unpack and secure fire extinguisher
In bracket on rear curbside step
(7)
Remove steel banding around accessory box, unpack, and Inventory contents
(8)
Refer to DA Form 2258, Depreservation Guide for Vehicles and Equipment, packed with power unit and
follow instructions given for putting unit into service
(9)
Stow all authorized accessories In the accessory box
b.
Inspection and Servicing of Generator Set. Refer to Service Upon Receipt of Materiel in TM 5-6115-457-12 or TM
5-6115-600-12, as applicable, for initial inspection and servicing procedures.
c.
Inspection and Servicing of Trailer. Refer to Service Upon Receipt of Materiel in TM 9-2330-247-14&P for initial
inspection and servicing procedures.
4-1
