ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
d.
Inspect all insulation for damage and missing dip halves.
e. Inspect EMI seals (55) for tears, looseness, and deterioration.
f.
Inspect door seals (56) for tears, looseness, and deterioration.
2-18-3 Repair.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC paint
dust is a health hazard and could cause personal injury if warning is not followed.
a. Repair all dents and cracks, and remove all loose paint.
b. Remove Iight corrosion with fine grit abrasive paper (Item 16, Appendix C).
c.
Repaint surfaces in accordance with TM 43-0139. (F) Use applicable directives.
d. Replace all cracked or stripped cage nuts (57, FIGURE 2-9).
e. Replace damaged insulation (24) and missing dip halves (23). Refer to Appendix D for fabrication of insulation.
f.
Replace EMI seals (55) that are loose or show any evidence of damage.
g. Replace damaged door seals (56).
2-18-4
Installation.
a. If removed, install plate (54, FIGURE 2-9) on fuel filler neck panel (27) with rivets (53).
b. If removed, install plate (52) on side panel (19) with rivets (51).
c.
Install right side panel (50) on generator set with bolts (39), (42),(46), and (48); flatwashers (41) and (43); lock-
washers (40) and (44); nuts (45); and assembled nuts (47) and (49).
d. Install door sills (37) and (38), and comer post (36) on generator set with bolts (28), (32), and (34); flatwashers
(29); Iockwashers (30); nuts (31); and assembled nuts (33) and (35).
e. Install fuel filler neck panel (27) on left side rear panel (19) with bolts (25) and assembled nuts (26).
f.
Install insulation (24) on baffle (22) with clip halves (23).
g. Install baffle (22) on left side rear panel (19) with bolts (20) and assembled nuts (21).
h.
Install left side rear panel (19) on generator set with bolts (12) and (16), flatwashers (13) and (17), Iockwashers
(14) and (18), and nuts (15).
i.
Install load entrance box (11) on rear panel (8) with bolts (9) and assembled nuts (10).
j-
Install rear panel (8) on generator set with bolts (1) and (4), flatwashers (3) and (5), Iockwashers (2) and (6),
and nuts (7).
2-47
