ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
2-18 REAR HOUSING SECTION.
2-18-1
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
n.
o.
p.
q.
r.
s.
t.
u.
2-18-2
a.
b.
2 - 4 6
Removal.
Shut down generator set.
Remove control box assembly, paragraph 2-19-2.
Remove air cleaner assembly, paragraph 2-73-3.
Remove output box access door and load terminal board access door, paragraph 2-14-1.
Remove rear engine access doors and air cleaner access door, paragraph 2-14-1.
Remove fuel filler neck, paragraph 2-88-1.
Remove auxiliary fuel pump, paragraph 2-87-3.
Remove fuel float module, paragraph 2-93-3.
Remove ether solenoid valve, paragraph 2-95-1.
Remove top housing panel, paragraph 2-16-1, step d.
Remove bolts (1 and 4, FIGURE 2-9), flatwashers (3) and (5), Iockwashers (2) and (6), nuts (7), and rear panel
(8) from generator set.
Remove bolts (9), assembled nuts (10), and load cable entrance box (11) from panel (8).
Remove bolts (12) and (16), flatwashers(13) and (17), Iockwashers (14) and (18), nuts (15), and left side rear
panel (19) from generator set.
Remove bolts (20), assembled nuts (21), and baffle (22) from panel (1 9).
Remove dip halves (23) and insulation (24) from baffle (22).
Remove bolts (25), assembled nuts (26), and fuel filler neck panel (27) from panel (19).
NOTE
Ensure output box assembly is secured prior to removal of corner post and door sills,
Remove bolts (28), (32), and (34); flatwashers (29); Iockwashers (30); nuts (31); assembled nuts (33) and
(35); comer post (36); and door sills (37) and (38) from generator set.
Remove bolts (39), (42), (46), and (48); flatwashers (41) and (43); Iockwashers (40) and (44); nuts (45); as-
sembled nuts (47) and (49); and right side panel (50) from generator set.
If necessary, drill out rivets (51) and remove plate (52) from side panel (19).
If necessary, drill out rivets (53) and remove plate (54) from fuel filler neck panel (27).
If necessary, remove output box EMI seals (55) from door sill (37), comer post (36), and right side panel (50).
lnspection.
Shut down generator set.
Inspect rear housing section panels for dents, cracks, loose paint, corrosion, and other damage.
Inspect all cage nuts (57, FIGURE 2-9) for cracking or stripped threads.
c.
