ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09243A-24/2
2-14-2
a.
b.
c.
2-14-3
a.
b.
c.
d.
e.
2-14-4
a.
b.
c.
d.
e.
f.
g.
lnspection.
Shut down generator set.
lnspect access doors, hinges, latches, and baffles for loose and missing hardware, cracks, dents, loose paint,
and corrosion.
Inspect data plates for readability, and loose or missing rivets.
Repair.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC paint
dust is a health hazard and could cause personal injury if warning is not followed.
Repair all dents and cracks, and remove loose paint.
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C).
Repaint surfaces in accordance with TM 43-0139. (F) Use applicable directives.
Replace unreadable data plates.
Replace loose or missing rivets.
Installation.
Install latches (21, FIGURE 2-5) in left rear engine access door (6) with screws (20) and nuts (19).
Install bracket (18) on engine access door (6) with bolts (17) and assembled nuts (16).
Install bracket (14) and holding rod (15) on engine access door (6) with bolts (13) and assembled nuts (12).
Install fuel system diagram (11 ) on document box (9) with rivets (10).
Install document box (9) on engine access door (6) with bolts (8) and assembled nuts (7).
Install left rear engine access door (6) and hinges (5) on generator set with bolts (3), washers (4), Iockwashers
(2), and nuts (1).
Close left side engine access doors.
2-15 CONTROL BOX TOP PANEL.
2-15-1 Removal.
a. Shutdown generator set.
b. Open battery access door and disconnect negative battery cable.
2-35
