ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
2-16 TOP HOUSINGS SECTION.
2-16-1
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
n.
o.
p.
q.
2-16-2
a.
b.
c.
Removal.
Shut down generator set.
Remove control box assembly, paragraph 2-19-2.
WARNING
Top housing panels can get very hot. Allow panels to cool down before performing main-
tenance. Failure to observe this warning could result in severe burns.
Remove bolts (1, FIGURE 2-7), flatwashers (3), Iockwashers (2), mount (4), and exhaust cover (5) from top
housing panel (6).
Remove bolts (7) and (10), flatwashers (9) and (12), Iockwashers (8) and (11), and top housing panel (6) from
generator set.
Disconnect radiator fill hose and overflow hose from radiator fill panel (13) and remove radiator fill panel (13)
from generator set.
Remove bolts (14), flatwashers (16), Iockwashers (15), and frame (17) from generator set.
Remove muffler, paragraph 2-71-1.
Remove bolts (18), assembled nuts (19), and air duct channels (20) and (21 ).
Remove bolts (22) and (24), assembled nuts (23) and (25), and panel (26).
Remove bolts (27), (29), and (33); flatwashers (30) and (35); Iockwashers (31) and (34); assembled nuts (28);
nuts (32); and top side panels (36) and (37) with top section floor panel (38).
Remove bolts (39), assembled nuts (40), and panel (41 ) from floor panel (38).
Remove bolts (42), assembled nuts (43), and support (44) from panel (41).
Remove bolts (45), assembled nuts (46), and side panels (36) and (37) from floor panel (38).
Remove bolt (47), assembled nut (48), and bracket (49) from angle (52).
Remove bolts (50), assembled nuts (51 ), and angle (52) from generator set. Open output box access door to
reach nuts (51 ).
Remove dip halves (53) and insulation (54) through (64) from top panel (6) as necessary.
Remove dip haIves (65) and insulation (66) and (67) from side panels (36) and (37) as necessary.
Inspection.
Shut down generator set.
Inspect all top housing section panels for dents, cracks, loose paint, and corrosion.
Inspect all cage nuts (68, FIGURE 2-7) for cracking or stripped threads.
2-39
