ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
APPENDIX D
FABRICATION/ASSEMBLY OF PARTS
D-1 INTRODUCTION.
This appendix includes complete instructions for fabricating or assembling parts as required on this generator set.
NOTE
All dimensions are expressed in inches, refer to TABLE D-1 for inches to metric conver-
sions.
D-2 ILLUSTRATIONS.
NOTES:
1. Dimensions shown are in inches.
2. Refer to TM 9-6115-644-24P for materials
required and length (L) of wire.
PROCEDURES:
1. Cut wire (1) to length indicated.
2. Strip 0.75 inch of insulation from each end of
wire (1).
3. Crimp terminal (2) on each end of wire (1).
FIGURE D-1. Cable Assembly, AC Power (P/Ns 88-22126-1 through 88-22126-7)
D-1