ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
NOTE
Maintenance for the fuel filter/water separator is found in the engine TM. Retain fuel
filter drain valve assembly for use with new filters.
2-93A FUEL FILTER/DRAIN VALVE ASSEMBLY.
2-93A-1 Removal.
a.
Remove clamp (60, FIGURE 2-26) and hose (61) from drain valve assembly.
b. Remove bolt (56), washers (57), and adapter (56). Discard washers (57).
c.
Remove valve (59) from adapter (58).
2-93A-2 Inspection. Check valve assembly for defects and proper operation.
2-93A-3 Installation.
a.
Replace adapter (56) on valve (59).
b. Install new washers (57) and bolt (56) to adapter (58) and tighten to bottom of fuel filter/water seperator.
c.
Install hose (61) and clamp (60) to drain valve (59).
2-94 ETHER CYLINDER.
2-94-1
a.
b.
c.
d.
e.
2-94-2
a.
b.
c.
d.
e.
2-94-3
a.
b.
c.
2-138
Removal.
Shut down generator set.
Open right side engine access doors.
Loosen wing nut (1, FIGURE 2-27) and unscrew ether cylinder (2) from ether solenoid valve (14).
Install cap (15) in solenoid valve (14).
Remove nuts (3), Iockwashers (4), bolts (5), washers (6), and ether cylinder bracket assembly (7) from generator
set housing.
Inspection.
Shut down generator set.
Open right side engine access doors.
Inspect cylinder bracket assembly for cracks, corrosion, stripped or damaged threads, or other damage.
Replace defective parts.
Close right side engine access doors.
Install bracket assembly (7, FIGURE 2-27) on generator set housing with bolts (5), washers (6), Iockwashers
(4), and nuts (3).
Remove cap (15) from ether solenoid valve (14).
Insert ether cylinder (2) through bracket (7) and screw into ether solenoid valve (14).
Installation.
