ARMY  TM  9-6115-644-10 AIR FORCE TO 35C2-3-446-11 MARINE  CORPS  TM  09249A/09246A-10/1 d.  Using  terminal  nut  wrench  (3,  Figure  2-4)  loosen terminal nuts (1) on terminals (2) selected in Step b. e. Insert ends of load cables through load cable en- trance box. Insert ends of cables into slots of load terminal studs (2). f. Tighten load terminal nuts (1). g.  Secure  wrench  (3)  in  bracket  inside  load  terminal board door, and close door. When using single phase connections, always attempt to balance loads between terminals (do not connect all loads between one terminal and LO). Failure to observe this caution can result in damage to generator set. Table 2-4. Load Terminal, AC Reconnection Board and AM-VM Transfer Switch Selection RECONNEC- TION BOARD POSITION 120/208 240/416 TERMINALS AM-VM TRANSFER SWITCH POSITION VOLTAGE READING CURRENT READING (TERMINAL) L1, L2, L3, L0 3 PHASE. (SINGLE   PHASE LOADS  CAN  BE SERVED  USING  ANY TERMINAL   TO   L0) L1-L0 L2-L0 L3-L0 L1-L2 L2-L3 L3-L1 120 VOLTS 120  VOLTS 120  VOLTS 208 VOLTS 208  VOLTS 208 VOLTS L1 L2 L3 NONE NONE NONE L1, L2, L3, L0 3 PHASE. (SINGLE   PHASE LOADS  CAN  BE SERVED  USING  ANY TERMINAL   TO   L0) L 1 -L0 L2-L0 L3-L0 L1-L2 L2-L3 L3-L1 240 VOLTS 240 VOLTS 240 VOLTS 416 VOLTS 416 VOLTS 416 VOLTS L1 L2 L3 NONE NONE NONE 2-18    Change  1