ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
APPENDIX D
FABRICATION/ASSEMBLY OF PARTS
D-1 INTRODUCTION.
This appendix includes complete instructions for fabricating or assembling parts as required on this generator set.
N O TE
All dimensions are expressed in inches, refer to TABLE D–1 for inches
to metric conversions.
D-2 lLLUSTRATIONS.
NOTES:
1.
Dimensions shown are in inches.
2.
Refer to TM 9-6115-643-24P for materials required and length (L) of wire.
PROCEDURES:
1.
Cut wire (1) to length indicated.
2.
Strip 0.75 inch of insulation from each end of wire (1).
3.
Crimp terminal (2) on one end of wire (1) and terminal (3) on other end.
FIGURE D-1. Cable Assembly, AC Power (P/Ns: 88-22126-1 through 88-22126-7)
D-1
