ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
e .
f .
g.
h.
i.
j.
Remove filler neck cap and tube assembly (14).
Loosen clamp (15) and disconnect hose (16) from adapter (17).
Remove adapter (17) from fitting (18).
Remove nut (19), washer (20), and fitting (18) from side of filler neck (23).
Remove bolts (21) and nuts (22) securing filler neck (23) to generator set housing.
Remove clamps (24) and (25), hose (26), and filler neck (23) from fuel tank opening. Cover fuel tank opening.
2.87.2. Inspection.
a.
b.
c.
d.
e.
f .
Shut down generator set.
Remove fuel tank filler neck, paragraph 2.87.1.
Inspect hose (26, FIGURE 2-27) for cracking, wear, or other damage.
Inspect filler neck (23) for corrosion, cracking, or other damage.
Inspect filler neck cap and tube assembly (14) for damage.
Install fuel tank filler neck, paragraph 2.87.3.
2.87.3. Installation.
a .
b.
c.
d.
e.
f.
g.
h.
Position hose (26, FIGURE 2-27), clamps (24) and (25), and filler neck (23) on fuel tank.
Install bolts (21) and nuts (22) securing filler neck (23) to generator set housing.
Tighten clamps (24) and (25).
Install fitting (18), washer (20), and nut(19) inside of filler neck (23).
Install adapter (17) on fitting (18) and connect hose (16) to adapter (17) with clamp (15).
Install filler neck cap and tube assembly (14).
Close fuel drain valve (29), install cap (27), and service fuel tank. Refer to TABLE 2-2 for proper fuel.
Connect negative battery cable. Close battery access door and engine access door.
2.88. FUEL DRAIN VALVE.
2.88.1. Removal.
a .
b .
c .
d .
Shut down generator set.
Open battery access door and disconnect negative battery cable.
Open left side engine access door.
Remove cap and chain assembly (27, FIGURE 2-27) from adapter (28).
WARNING
Diesel fuel is flammable and toxic to eyes, skin, and respiratory tract.
Skin/eye protection required. Avoid repeated/prolonged contact. Good
general ventilation is normally adequate.
2-129
