ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
e
Remove overflow bottle (5) from wire holder (10).
f.
Remove bolts (6), nuts (7), lockwashers (8), and wire holder (10) from mount (14).
g
Remove bolts (11), nuts (12). lockwashers (13), and mount (14) from engine.
2.84.3
Installation
a
Install mount (14, FIGURE 2-26) on engine with bolts (11), nuts (12). and lo&washers (13)
b.
Install wire holder (10) on mount (14) with bolts (6), lockwashers (8), and nuts (7).
C
Install coolant overflow bottle (5) in holder (10) and connect hoses (2) and (4) with clamps (1) and (3)
d Remove cap (15).
e.
Fill overflow bottle (5) with coolant to the COLD level. Refer to TABLE 2-1 for proper coolant.
f. Install cap (15)
g. Start generator set, check for leaks, and run until normal operating temperature is reached.
h. Remove cap (15).
i.
Add coolant to HOT level of overflow bottle (5).
j.
Install cap (15) and close left side engine access door.
2-124
Change 4
