ARMY TM 9-6115-642-24
AIR FORCE TO 35C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
TABLE 2-10. Diagnostic Connector Connection Points
NOTE
The Diagnostic Connector can be a useful troubleshooting tool. Refer to FIGURE 2-13
for pin positions.
PIN
DESCRIPTION
B
AC chassis ground (GND)
D
DC ground
F
DC exciter field voltage (positive)
J
DC exciter field voltage (negative)
K
DC voltage across engine fuel solenoid coil
N
DC starter motor solenoid coil
0
DC voltage across auxiliary fuel pump
P
DC voltage S1 terminal 7
R
DC voltage S1 terminal 3
T
DC voltage across starter crank relay coil
U
DC voltage (output to DC circuit breaker)
V
DC voltage across output circuit interrupter coil
X
DC starter motor (motor side of solenoid contacts)
Z
DC voltage across fuel level contacts
a
DC voltage across low oil pressure switch
b
DC voltage across low oil pressure switch
d
DC battery charging voltage (input to DC circuit breaker)
* With Generator Set Operating,
EXPECTED OUTPUT *
Continuity 0 Volts (*)
Continuity 0 Volts (*)
0-45 VDC (4)
0-45 VDC (5)
24 VDC (1)
24 VDC (2) or (6)
24 VDC (3) (7)
24 VDC (6)
24 VDC (1) (3) (6)
24 VDC (2) or (6)
24 VDC (*)
24 VDC (*)
24 VDC (2) or (6)
24 VDC (1)
0 VDC (1)
24 VDC (*)
24-27.6 VDC (*)
(1) Place MASTER SWITCH in PRIME/RUN position.
(2) Place DEAD CRANK switch in CRANK position.
(3) Place MASTER SWITCH in PRIME/RUN AUX. FUEL position.
(4) Read between Pin F and J.
(5) Read between Pin J and F.
(6) During Engine Starting..
(7) Auxiliary Fuel Pump in operation (Note Fuel Level Must be Low), MASTER SWITCH in PRIME/RUN position
2-37 CONTROL PANEL LIGHTS.
2-37.1 Inspection.
a.
Shut down generator set.
b.
Release control panel by turning two fasteners and lower control panel slowly.
C.
Inspect control panel lights for cracks, stripped threads, corrosion, and other damage.
d.
Raise and secure control panel.
2-37.2
Removal.
a.
Shut down generator set.
b.
Open left side engine access door and disconnect negative battery cable.
C.
Release control panel by turning two fasteners and lower control panel slowly.
d.
Tag and disconnect panel light (3, FIGURE 2-14) electrical leads.
e.
Remove nut (1) and washer (2).
f.
Remove panel light (3) from control panel.
2-64 Change 2