ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
3-6-2. Installation - Continued.
p.
Install bolts (80, Figure 2-8) and nuts (81) securing door sills (82) and (83) to center housing panel (62,
Figure 2-9).
q.
From right side of generator set, perform following installation procedures:
(1) Install bolt (70, Figure 2-8), nut (71), Iockwasher (72), washer (73), mounting plate (74), and grounding
(2) Connect coolant drain hose (35, Figure 2-20) at engine block drain valve.
(3) Connect electrical connections to heater plugs, refer to TM 9-2815-252-24. Remove tags.
(4) Connect electrical connections to alternator (9, Figure 2-5). Remove tags.
(5) Install starter, refer to TM 9-2815-252-24.
(6) Connect electrical connections to magnetic pickup (7, Figure 2-25). Remove tags.
(7) Connect four pin connector-J5 under control box.
r.
s.
t.
u.
v.
w.
x.
y.
z.
aa.
ab.
ac.
ad.
ae.
af.
3-14
NOTE
If only the generator was removed, proceed to step s.
Install muffler, paragraph 2-65-3.
Install hose (3, Figure 2-19) between air cleaner (7) and air intake manifold. Tighten two damps (2).
NOTE
If only the generator was removed, proceed to step v.
NOTE
Fan shroud is in two pieces.
Install bolts (13, Figure 2-20), nuts (14), and fan shroud (15).
Install bolts (18, Figure 2-8), Iockwashers (19), washers (20), bolts (21), nuts (22), and air deflector panels (23),
(24), and (25) to front housing (56).
Install bolts (7, Figure 2-9), nuts (8), Iockwashers (9), and washers (10) securing lower door sill (11) to skid
base.
Install nut (5) and bolt (4) securing center door post (6) to skid base.
Install nuts (1, Figure 2-26), Iockwasher (2), washers (3), and bolts (4) securing load output terminal board
assembly (13) to skid base.
Connect wires at terminal board TB3 (16, Figure 4-11) Ieading from generator. Remove tags.
Install top housing panel, paragraph 2-17-4.
Install control box top panel, paragraph 2-16-4.
NOTE
If only the generator was removed, proceed to step ad.
Service coolant system, paragraph 2-1-2-2.
Service engine lubrication system, paragraph 2-1-2-4.
Install screws (2, Figure 2-20), washers (3), and fan guards (4).
Install batteries, paragraph 2-12-5.
NOTE
If only the generator was removed, proceed to step ag.
Prime and bleed engine fuel system, refer to TM 9-2815-252-24.
rods (75).
