ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
2-53-2. Testing.
a.
Shut down generator set.
b. Open left side engine access door and disconnect negative battery cable.
c.
Release control paneI by turning two fasteners and lower control panel slowly.
d. Set multimeter for ohms and connect between PANEL LIGHTS switch terminals.
e.
Place switch in OFF position. Multimeter should indicate open circuit.
f.
Place switch in ON position. Multimeter should indicate continuity.
g.
Replace PANEL LIGHTS switch if indications are other than above.
h.
Raise and secure control panel.
i.
Connect negative battery cable and close access door.
2-53-3. Removal.
a.
Shut down generator set.
b. Open left side engine access door and disconnect negative battery cable.
c.
Release control panel by turning two fasteners and lower control panel slowly.
d.
Tag and disconnect PANEL LIGHTS switch (67, Figure 2-14) electrical leads.
e.
Remove nut (65) and washer (66).
f.
Remove PANEL LIGHTS switch (67) from control panel.
g.
Remove tab washer (68) from switch stem.
2-53-4. Installation.
a.
Install tab washer (68, Figure 2-14) on PANEL LIGHTS switch (67).
b.
Insert PANEL LIGHTS switch (67) into control panel.
c.
Install washer (66) and nut (65).
d. Connect electrical leads and remove tags.
e.
Raise and secure control panel.
f.
Connect negative battery cable and close access door.
2-54. CONTROL PANEL.
2-54-1. Inspection.
a.
Shut down generator set.
b.
Release control panel by turning two fasteners and lower control panel slowly.
c.
Inspect control panel and hinge for cracks, dents, loose paint, corrosion, and other damage.
d.
Raise and secure control panel.
2-84
