ARMY TM 9-6115-641-10
AIR FORCE TO 35C2-3-456-11
1-7.17 Oil Filter (1). The oil filter is located in the engine
compartment on the left side. The filter removes
impurities from the engine lubricating oil.
1-7.18 Fan Belt (13). The fan belt is located in the
engine compartment on the front of the engine. The belt
drives the fan, water pump and battery charging
alternator.
1-7.19 Water Pump (8). The water pump is located in
the engine compartment on the front of the engine. The
pump circulates the engine coolant through the engine
block and the radiator.
1-7.20 Dead Crank Switch (5). The Dead Crank switch
is located in the engine compartment on the left side.
For maintenance purposes the switch allows the engine
to be cranked without starting.
1-7.21 Convenience Receptacle (22). The convenience
receptacle is a 10 Amp, 120 VAC receptacle used to
operate small plug in type equipment. It is protected by
a Ground Fault Circuit Interrupter located below the
malfunction indicator (1-7.12), an overload circuit
breaker located inside the control box, and an in-line
fuse on generator sets, contract number DAAK01-88-D-
D080. The convenience receptacle power is available at
all times during operation of the generator set.
1-7.22 Frequency Adjust Control (20). The Frequency
adjust control is located at the rear left side of generator
set. It is used to adjust the generator frequency output
1-8 DIFFERENCES BETWEEN MODELS. The
differences between models of the generator sets
covered in this manual are as follows:
Model MEP-802A is equipped with a 60 Hz generator.
Model MEP-812A is equipped with a 400 Hz generator.
1-9 EQUIPMENT DATA. For a list of Leading
Particulars refer to TABLE 1-1
Table 1-1. Leading Particulars
1.
Generator Set:
Model Numbers
5 kW 60 Hz Tactical Quiet
MEP-802A
5 kW 400 Hz Tactical Quiet
MEP-812A
National Stock Numbers
5 kW 60 Hz Tactical Quiet
NSN 6115-01-274-7387
5 kW 400 Hz Tactical Quiet
NSN 6115-01-274-7391
Overall Length
MEP-802A
50.6 in. (128.6 cm)
MEP-812A
50.6 in. (128.6 cm)
Change 2 1-7
