ARMY TM 9-6115-639-13
AIR FORCE TO 35C2-3-386-51
MARINE CORPS TM 10155A-13/1
3-6. CONTROL BOX AND OUTPUT PANEL ASSEMBLIES.
a. Inspect control panel switches for ease of operation. Ensure that switches spring back to position.
b. Clean hour, fuel level, and voltage meters with a clean dry cloth. Inspect meters for broken glass or
improper indication.
c. Conduct fault module indicator self test by depressing the FAULT RESET / PUSH TEST pushbutton.
All indicator lights should illuminate.
d. Open control panel. Check rear of controls and indicators for obvious damage and evidence of
electrical short. Inspect sealing gasket for cuts, tears, and security of attachment. Close control panel.
e. Inspect convenience receptacle cover for security of attachment. Inspect slave receptacle for damage.
Make sure that cover is securely attached.
f. Inspect load and ground terminals for cracks, missing surge arrestors, or other obvious damage.
g. If damage is found, notify unit level maintenance personnel for repair.
3-7. FUEL SYSTEM.
a. Open enclosure cover and inspect inside of enclosure for evidence of fuel leakage. Inspect fuel tank
for signs of damage. Check that tank is securely attached to skid base.
b. Inspect fuel hoses for cuts, tears, or evidence of deterioration. Check that hoses are securely fastened
to fittings.
c. Close enclosure cover and lock using latches.
d. Inspect fuel tank fill cap and auxiliary fuel connection cap for security of attachment.
e. Remove fuel tank fill cap from filler neck. Remove fuel strainer and inspect for collected
contaminants. Clean strainer and install. Install fuel tank fill cap and tighten.
f. If damage is found, notify unit level maintenance personnel for repair.
3-8. FUEL FILTER / WATER SEPARATOR.
a. Open enclosure cover to gain access to fuel filter / water separator.
b. Inspect filter / separator drain valve for damage or evidence of leakage. If leak or damage is found,
notify unit level maintenance personnel for repair.
3-10
Change 1
