ARMY TM 9-6115-639-13 AIR FORCE TO 35C2-3-386-51 MARINE CORPS TM 10155A-13/1 4-40.  FUEL SENDER MAINTENANCE This task covers removal, inspection, and installation. INITIAL SETUP Tools: Equipment Condition: Tool Kit, General Mechanic’s Automotive Generator set shut down (Para. 2-9) (Item 2, App. B, Sect. III) Battery cables disconnected Cable disconnected for SLAVE RECEPTACLE A.    REMOVAL. 1. Unlock  main  access  cover  latches  and  lift  cover to open. NOTE Note position of fuel sender (2) and gasket (10) prior to removing from fuel tank (5). 2. Tag  and  disconnect  electrical  wire  (1,  Figure  4- 31) from fuel sender (2) by removing captive nut and washer (3) from stud (4) on sender. 3. Remove fuel sender (2) and gasket (10) from fuel tank (5) by removing five screws (6), lockwashers   (7),   and   washers   (8).      Remove remaining wires (9). B.    INSPECTION. 1. Inspect sender for corrosion and obvious damage. 2. Inspect  electrical  wiring  for  cuts,  crimps,  bare wire, or other damage. 3. Remove   and   replace   any   component   that   is damaged  to the extent that it will effect the safe operation of the generator set.                                                                                  Figure 4-31.  Fuel Sender 4-82