TM 55-6115-498-40
(13) with lock wire (item 15, table 2-3). Secure
CAUTION
drilled head screw (6) to brush access cover as-
The dial setting gage (table 2-1) shall
sembly (7) with lock wire (item 16, table 2-3)
be used to avoid any damage and/or in-
in accordance with Military Standard MS 33540
correct readings. Do not use a torque
wrench to adjust the compression spring.
(ASG).
(18) After the final test procedure has es-
tablished optimum position of brushes, lock the
end bell assembly in position. Using the notch
in the end bell for location, press in roll in
(35) flush to the Astor housing. If there is no
drilled hole in the stator housing, refer to step
(19).
(19) If required because either winding and
shoe pole assembly (14, figure 3-3) or stator
housing (22) was replaced, or as a result of
testing, drill a 0.062, plus 0.003, minus 0.000
inch diameter hole through the stator housing,
using the notch in the end bell for location.
Then press in roll pin (35, figure 3-1) flush
to the stator housing.
3-13
