(5)
Tighten each locknut on setscrew while maintaining adjustment with hcx-
wrench. Install cap, and tighten securely.
Acceleration Control, Model T-62T-2A. (See figure 3-3.)
b.
CAUTION
Adjustment is critical. Mark the initial position of adjusting
lever and make adjustments in small increments (1/16-turn
or less).
(1) To adjust acceleration schedule, loosen wingnut; rotate adjustment lever
clockwise to increase acceleration fuel flow schedule, and counterclock-
wise to decrease the flow.
(2) To adjust rated speed, loosen locknut and insert a 3/32-inch, hex-type
wrench into the rated speed adjustment setscrew. Rotate clockwise to
increase speed, and counterclockwise to decrease speed. A one-quarter
turn (SO degrees) in either direction will change the speed accordingly by
approximately 65 rpm (approximately 1.5 percent speed).
Figure 3-3.
Fuel Control Adjustment, Model T-62T-2A
3-7
