TM5-6115-632-14&P
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
Install washer (14) and cotter pin (13) to secure shaft (15).
Assemble handbrake lever assembly (12) using two screws (9) and two spacers (10).
Make certain top screw (9) goes through spacer (18) and bottom screw (9) goes through
handbrake cable clevis.
Position assembled handbrake lever assembly (12) on trailer chassis (5) and install two
nuts (11). Tighten hardware.
Repeat steps (6) through (10) to assemble and install curbside handbrake lever
assembly.
Install generator set (paragraph 5-7, b.).
Install accessory box (paragraph 4-18, b.).
Install tarpaulin support and four bow assemblies (paragraph 3-11, b.(2)).
Install fitted cover (paragraph 3-11, a.(2)).
5-4.
Fitted Cover Repair. Repairs to the fitted cover shall be made in accordance with FM 10-16,
Fabric Repairing.
5-5. Accessory Box Repair. (See figure 5-3.) The accessory box is repaired by replacing the hasp,
the catches and the footmans loops, as required. The box itself may be straightened, welded, and
repainted. If required, repaint in accordance with MIL-T-704, Type F, color Green, No. 383 of MIL-
C-46168.
a, Catch and Hasp Replacement.
(1) Grind off or drill out solid rivets (1, figure 5-3) securing catch or hasp (2) to accessory
box (3).
(2) Position new catch or hasp (2) on accessory box and secure with solid rivets (1).
(3) Touch up with paint as required.
Figure 5-3. Accessory Box Repair,
5-6
