TM 5-6115-632-14&P
(8) Remove cotter pin (13), washer (14), shaft (15), and pulley (16) from handbrake lever
assembly (12).
(9) Working under trailer, pull handbrake cable clevis (17) back through the holes in the front
two braces on the trailer body.
(10) Repeat steps (7) through (9) to remove and disassemble curbside handbrake lever
assembly.
WARNING
When lifting trailer body, use lifting equipment with a minimum lifting capacity
of 500 lb. Do not stand under trailer body while it is being lifted. Failure to
observe these precautions can cause injury to personnel or damage to
equipment.
(11) Using suitable lifting equipment with a minimum lifting capacity of 500 lb, lift trailer body
(4) off of trailer chassis (5).
b. Repair.
Repair of the trailer bed and fenders is limited to straightening, welding, and
repainting. If required, repaint in accordance with MIL-T-704, Type F, color Green, NO. 383 of MIL-
C-46168.
c.
(1)
(2)
(3)
(4)
(5)
Installation.
WARNING
(6)
(7)
When lifting trailer body, use lifting equipment with a minimum lifting capacity
of 500 lb. Do not stand under trailer body while it is being lifted. Failure to
observe these precautions can cause injury to personnel or damage to
equipment.
Using suitable lifting equipment with a mimimum lifting capacity of 500 lb, lift trailer body
(4) onto trailer chassis (5) and aline mounting holes.
Insert 10 screws (1) with flat washers (2) through trailer bed and through trailer chassis
frame rails.
Working under trailer, install one flat washer (2) and one nut (3) on each screw (1).
Insert 16 screws (6) with 16 flat washers (7) through trailer body braces into trailer
chassis.
Working under trailer, install one flat washer (7) and one nut (8) on each screw (6).
Tighten hardware to secure trailer body to trailer chassis.
Feed roadside handbrake cable clevis (17) forward through holes in front two braces on
trailer body.
Wrap handbrake cable around pulley (16), position pulley in handbrake lever assembly
(12) and insert shaft (15).
5-5
