TM 5-6115-626-14&P
(4) Insert five screws (1) with flat washers (2) down through fender (4) into trailer frame (5).
(5) Working under fender, install one flat washer (2) and one nut (3) on each screw (1) and
tighten.
(6) Insert six screws (6) with flat washers (7) through fender (4) into front step (9). Install
one washer (7) and one nut (8) on each screw (6) and tighten.
(7) Insert four screws (10) with flat washers (11) through fender (4) into rear step (13).
Install one washer (11) and one nut (12) on each screw (10) and tighten.
4-23.
Personnel Platform Replacement. (See figure 4-11). The platform is mounted to the rear of
the trailer to facilitate access to the generator set controls and indicators.
a. Removal.
(1) Remove two screws (1, figure 4-1 1), four flat washers (2) and two nuts (3) securing plat-
form (4) to mounting brackets (5).
WARNING
Support platform while removing anchors. When anchors are removed,
platform will drop.
(2) Remove two platform anchors (6) by pushing in on button on head of pin while pulling pin
out of mounting hole.
NOTE
Mounting brackets are fastened with lock nuts. Removal may damage locking
capability when reinstalled. Do not remove mounting brackets unless they are
damaged.
(3) Remove three screws (7), three flat washers (8) and three nuts (9) from each mounting
bracket (5) and take mounting brackets off of trailer frame (10).
b. Installation.
(1)
(2)
(3)
NOTE
If mounting brackets have not been removed, omit step (1).
Position each mounting bracket (5) on trailer frame (10). Insert three screws (7) through
frame into each bracket. Install one washer (8) and one nut (9) on each screw and
tighten.
Holding platform (4) in vertical position, position platform on mounting brackets (5) so
that holes in platform line up with holes in brackets and install platform anchors (6) in
upper mounting hole on each side of platform.
Secure platform (4) to brackets (5) with two screws (1), four flat washers (2) and two
nuts (3).
4-22
