TM 5-6115-626-14&P
(4) Aline two mounting holes in rear step bracket (4) with holes in trailer frame (6) under
taillight (7) and insert two screws (1).
(5) Slide S-hook at chain end of platform anchor (5) onto threaded end of lower screw (1)
inside trailer frame (6).
(6) Install one flat washer (2) and one nut (3) on each screw (1) and tighten.
4-22.
Fender Replacement. (See figure 4-10.) The trailer assembly fenders are symmetrical, and
replacement procedures are the same for each.
a. Removal.
(1) Remove five screws (1, figure 4-10), ten fIat washers (2) and five nuts (3) securing
fender (4) to trailer frame (5).
WARNING
There are five sets of hardware securing fender to rear step and seven sets of
hardware securing fender to front step. This hardware should be removed in
sequence from trailer frame outward. In this way, last two screws on front and
rear lower fender edge will support fender until you are out from underneath.
(2) Remove six screws (6), 12 flat washers (7) and six nuts (8) securing fender (4) to front
step (9).
(3) Remove fours screws (10), eight flat washers (11) and four nuts (12) securing fender (4)
to rear step (13).
WARNING
4-20
Support fender while removing remaining two screws. When screws are
removed, fender will drop.
(4) Remove one screw (6), two flat washers (7) and one nut (8) securing fender (4) to front
step (9).
(5) Remove one screw (10), two flat washers (11) and one nut (12) securing fender (4) to
rear step (13).
(6) Remove fender (4).
b. Installation.
(1) Position fender (4) on trailer.
(2) Insert one screw (10) with flat washer (11) through lower outside edge of fender (4) into
rear step (13), and insert one screw (6) with flat washer (7) through lower outside edge of
fender (4) into front step (9).
(3) Install one washer (11) and one nut (12) on screw (10), and one washer (7) and one nut
(8) on screw (6). Tighten hardware.
