TB 9-6115-643-13
6
8
7
5
2
3
4
4.
Approximately 10" from inside of left door hinge, Figure 5-2, drill 1 7/16" diameter hole in top left side of bulkhead
housing.
5.
Remove rear panel from Generator Set in accordance with TM 9-6115-643-24.
6.
Attach one end of exhaust hose (1), to exhaust elbow (8) with clamp (7). Attach it to exhaust port on heater. Apply 2
thick beads of RTV around exhaust port of heater and attach exhaust elbow to heater. Move elbow in a position that
doesn't interfere with anything in the route to the hole drilled in step 4.
7.
Route hose through hole drilled in step 4. Install clamp (5) and use sealant provided in kit around hose. Open to prevent
movement. Attach at middle of exhaust hose (1), to the top of the bulkhead at first screw closest to the heater. Secure
using spacer (6), nut (4), lock washer (3), and washer (2).