TB 9-6115-643-13
17.
Open top right front panel door.
18.
Remove and discard pins from P6-16, 17, and 24, Figure 5-6.
19.
Install wiring harness in accordance with wiring diagram. Secure harness with straps contained in kit.
NOTE
Install fuse, (25 AMP, 32 V) if not already installed.
20.
Connect (+) terminal wire of fuse holder (1) to the slave receptacle. Then install fuse XF1 into fuse holder (bottom left
radiator housing).
21.
Drill a 1/5" hole at lower left hand radiator side stiffener and mount fuse holder (1), using screw, washer, and nut
provided in kit. Refer to generator TM 9-6115-643-24.
22.
Open control panel access door (1), Figure 5-7.
23.
Locate operating instruction plate (2) and heater function codes plate (3) and match drill 3/16" holes in control panel
access door (1). Plates shall be readable when the door is open.
24.
Install rivets (4). Rivet head shall be to the outside of the unit.
25.
Locate heater switch label (7) and drill a 5/16" and a 1/2" hole in control panel (8).
26.
Install heater switch label (7), indicator light (6), and toggle switch (5).
27.
Remove and discard pins from J6-16, 17, and 24, Figure 5-6.
28.
Install electrical leads in accordance with wiring diagram (refer to Figure 5-6). Secure leads with straps contained in
kit.
WARNING
The coolant in the system shall contain the proper mixture of water and
antifreeze to prevent coolant from freezing or slushing. Failure could
cause engine damage and/or personal injury.
29.
Add coolant to proper level.
30.
Reinstall rear panel in accordance with TM 9-6115-643-24.
31.
Connect positive and negative battery cables.
32.
Start and run engine until the radiator thermostat has opened.
5-9
