TM 9-6150-226-13
Section III.
DIRECT SUPPORT MAINTENANCE PROCEDURES
Section Index
Subject
Cable Connector
Enclosure Assembly
Feeder/Distribution Center Connectors
General
Latch
Maintenance Procedures
Scope Maintenance
Page
5-17
5-29
5-25
5-4
5-28
5-5
5-4
5-7.
SCOPE MAINTENANCE.
Direct support maintenance replaces and repairs unserviceable components
of DISE and PDISE as authorized by the Maintenance Allocation Chart (MAC).
5-8. GENERAL.
WARNING
High voltage is present in this system. DISE and
PDISE supports equipment using 120/208 V ac. Do
not perform maintenance procedures with cables
connected to power.
Death or serious injury may
result.
a.
This section provides the procedures to be followed in the testing,
repair, and fabrication of DISE and PDISE cable assemblies to the extent
authorized at the direct support maintenance
level by the Maintenance
Allocation Chart (MAC).
b.
DISE and PDISE cables are designed for use in moist climatic
conditions; cable splices are unauthorized.
Cable assembly repair is limited
to shortening the cable by cutting off the damaged portion and reattaching the
connector.
c.
Determine the serviceability of an item by comparing its physical,
mechanical,
and/or electrical
characteristics with established standards
through examination.
5-4
